Enclosure design

Enclosures designed around the real board.

Cases, housings, mounts and fixtures for electronics, designed from the actual 3D model of the board, checked for collisions and printability, then 3D-printed and test-fitted. Measurements from each print feed the next design.

  • 17

    Written findings measured on real prints, used to set every tolerance

  • 0.28 mm

    How much smaller a 2.1 mm round hole prints. The design compensates.

  • Under 3 hours

    Print time for the Monarch Mini V2 housing

What you get

  • Designed around the board

    Built from the board’s 3D model, with openings for connectors, buttons, displays and cables where they really are.

  • Collision check

    Every part checked against the board and against each other before anything is printed.

  • Printability check

    Thin walls, overhangs and bridges checked, then a slicer run on the real printer settings.

  • Print and test fit

    Printed and fitted to the real board. What the print shows goes into the next revision.

  • Mounts and fixtures

    Brackets, trays, mounts and test fixtures designed the same way as the enclosure.

  • Files you own

    STEP and STL files, ready for printing or for a machining or molding shop.

Price

An enclosure for an existing board gets a fixed price after a 30-minute call. A new device follows the product steps.

  1. Enclosure for your board

    fixed price

    in writing within 2 business days of the call

    Send the board files or the board, and how the product will be used. You get scope, deliverables, date and price in writing before work starts.

  2. Feasibility sprint

    $1,500

    about 1 week

    A one-page design, a parts list with live prices, a 3D view of the board and enclosure, and unit cost at 100 and 1,000 pieces. Credited in full toward the prototype.

  3. Prototype sprint

    from $7,500

    3 to 5 weeks

    Two assembled boards, a printed enclosure, firmware that performs the main function, a test report and every source file.

The rest of the build

Enclosure design is one layer. The rest is built here too.

Boards, enclosures, firmware, software and AI from one shop, designed against the same requirements, so the pieces fit the first time.

How it works

A fixed price before any work starts.

  1. Call

    Thirty minutes, free. You describe what you need. You hear whether it fits and roughly what it costs.

  2. Fixed price in writing

    Within two business days of the call: scope, deliverables, date and price. No hourly billing.

  3. Build, with a demo every week

    You see working results as they are built, and you can change direction when you need to. A change in scope gets its own fixed price before it is built.

  4. Hand-off

    You own the design files, source code and documentation once the invoice is paid.

FAQ

Yes. From the board’s 3D model if you have the design files, or from measurements of the board if you do not.

For prototypes and small batches, yes. For larger runs, the STEP files go to a molding or machining shop, and the design is reviewed for that process first.

Yes. Scope, deliverables, date and price are written down before work starts. If you change the scope, you get a fixed price for the change before it is built.

You do, once the invoice is paid. You receive the source files, not only the outputs.

Don’t see your project?

If it involves electronics, electrical systems or software, send it. You get a fixed price either way.

Test systems
Data acquisition
Equipment upgrades
Machine controls
Sensors and instruments
Devices and prototypes
Circuit boards
Firmware
Enclosures
Business software
Apps
AI assistants
Measurement tools
Describe it

Tell us what you need built.

A few sentences is enough. You get a reply within one business day.

  • Fixed price in writing before work starts

  • You own the files

Start here

Protected by Vercel Bot Protection